Putting 2 panels in Parellel to 1 microinverter?

[resechalex]

INVERTER.pngCOMPATABILITY.pngPANEL.png




Looking at adding a ground mount to my system and wanting to save some money by buying used 250w panels and hooking 2 in parallel to each input of one Apsystem DS3-L microinverter to keep the cost down has anyone done this before. I have used apsystem compatabilty calculator and is shows it will work i used the number off the data sheet but i doubled the amp number being it is in parallel. Any input on this.

[Ampster]

I could not read the attachments. What is the Wattage output of the micro inverter?

[resechalex]

I could not read the attachments. What is the Wattage output of the micro inverter?

output shows 768va

[Ampster]

output shows 768va

Then you should be fine putting two in parallel. you might even be able to put three in parallel since the micro will not draw any more current than it can process and the voltage limit is the critical issue when matching panels to controllers and inverters.