A 220v/50Hz Grid-tie installed in a 220v/60Hz house?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • computerpc101
    Member
    • Dec 2011
    • 31

    #16
    I got my cheap 600Watts Ebay Power jack GTI, it is 28V-55V input/output 110V 60HZ version not 220V 50HZ, inexpensive and very basic model.

    It comes with user manual, very low quality and teach me how to repair it.

    I tested it with batteries with 1/2 power point 300Watts, Its efficiency is about 83% and it is quite close to User manual rated 85%(seller post 90%, lie), Its sine waves output is slightly not very clean and it sync with 60HZ very well, I can not do farther testing because my setup is not ready.

    It is not hard to Sync between 50Hz to 60HZ but slightly increase waveform distortion and slightly lower efficiency, As long as your 220V 60HZ work,, However, it does voltage cutout below 25 Volts and above 60Volts.

    Biggest problem for Ebay's Power jack GTI is not that it is only lower efficiency, It burned out easy which end up cost more money.

    I think that I make a mistake, I did farther research, FEEbay's power Jack is cheap and low quality, I paid $139 including shipping, However, I find that it comes from China, In China, If I pay slightly more, EX, $169 including shipping, I can get one much better quality GTI than Power jack with 94% efficiency plus other functions, FEEbay's version of Power jack is almost the lowest quality GTI in China.

    $139 GTI from Retailor = $25( Courier) + $25(end Retailer) + $25 ( wholesaleer) + $30 Labour cost + $34 material cost
    $169 GTI from Retailor = $25( Courier) + $25(end Retailer) + $25 ( wholesaleer) + $35 labour cost + $59 material cost
    I think that it is what you pay and what you get, ThereFore $59 VS $34 = better Quality

    I do like Sunny boy Germany GTI, However, It is much heavier ( quality) for shipping and It uses very high input voltage, 200V to 600V, It needs to serial connect many solar panels to start it which is not suitable for small hobbyist who use few solar panels as a small starter project.

    Comment

    • noelana
      Junior Member
      • Jun 2014
      • 12

      #17
      A 220v/50Hz Grid-tie installed in a 220v/60Hz house?

      Originally posted by rboos
      Thank you for the answers!

      Actually it is installed and generating an average of 330W (from a 2x200W PV array), so somehow it is tied and working.

      It completed 7 days now, and my doubt was about any (1)drawbacks it could generate (burnt lightbulbs or something) or (2)loosing some energy while converting and not synchronizing a 100%... but it seems to be working ok.

      The seller sent me this model and does not have a 60Hz version to trade (of the same model), so I guess I might be loosing some percentage of the PV energy, what the GTI manages to "inject" is used and the out-of-frequency part gets lost, maybe?

      What actual wattage should I get from a 400W PV array in full sunlight? 80%? 90%? Or does it actually produce the full spec wattage?

      Maybe I will accept the seller idea of exchanging this one for a couple 300W - 220v/60Hz and then check if the overall wattage furnished into the grid if higher... then I would know if the frequency difference was responsible for some loss..?

      Thank you again,

      Rod!
      Hi rboos,

      May I know if you'r still using the 50Hz inverter in your house that's having 60Hz supply from the grid? Is it still working well?
      I have the same situation, It is hard to get a good quality grid tie inverter having 220v-60hz specs, so i'm planning to buy a 220v-50hz and that's why I'm looking for a thread about this subject.

      Thanks,
      Noel

      Comment

      • Sunking
        Solar Fanatic
        • Feb 2010
        • 23301

        #18
        Originally posted by noelana
        Hi rboos,

        May I know if you'r still using the 50Hz inverter in your house that's having 60Hz supply from the grid? Is it still working well?
        I have the same situation, It is hard to get a good quality grid tie inverter having 220v-60hz specs, so i'm planning to buy a 220v-50hz and that's why I'm looking for a thread about this subject.
        Don't hold your breath waiting for an answer because the OP has not logged in for 3 years.

        MSEE, PE

        Comment

        • noelana
          Junior Member
          • Jun 2014
          • 12

          #19
          Originally posted by Sunking
          Don't hold your breath waiting for an answer because the OP has not logged in for 3 years.

          ow, so sad, thanks for the info sunking!

          Comment

          • old dodge
            Junior Member
            • Mar 2013
            • 1

            #20
            Originally posted by Sunking
            This site will give you an overall picture
            Great info to have on hand

            Comment

            Working...