Solar PV direct Pumping system. What size solar panel do I need?
Collapse
X
-
-
This project would really be much simpler if you just went with a small sealed 12 volt battery and a small inexpensive controller.
2.2kw Suntech mono, Classic 200, NEW Trace SW4024Comment
-
Comment
-
Comment
-
What is the intended use of this pump? Are you charging a tank or just using this for watering? Have you bought the panel already, buying a battery voltage panel is a big mistake cost and performance wise. If you can operate the pump at a lower voltage like 9-10V, I would do that. Solar is a lot like a puppy or wife, it seems like a good idea at first.Comment
-
Hello! I am working on a project where I need to pump water from one tank to another one. I am located in Rockford, IL and need to pump this system for a few hours. The pump that I am looking at using is a Shurflo 12 VDC pump (Model # 2088-514-145). I need 10 PSI and 2.90 GPM and the current needed for the pump is 5.6. I am not going to use any batteries as they are expensive, but I am wanting to use a Shurflo pump controller, 902-200 9300 series 12/24 V, to get a better performance from the pump. The one thing I am not sure of is what size solar panel do I need to run this pump? I calculated that I would need a 100 Watt pump, but I am not sure if this is correct.Last edited by LETitROLL; 03-29-2018, 11:13 PM.Comment
-
Comment
-
Powerfab top of pole PV mount (2) | Listeroid 6/1 w/st5 gen head | XW6048 inverter/chgr | Iota 48V/15A charger | Morningstar 60A MPPT | 48V, 800A NiFe Battery (in series)| 15, Evergreen 205w "12V" PV array on pole | Midnight ePanel | Grundfos 10 SO5-9 with 3 wire Franklin Electric motor (1/2hp 240V 1ph ) on a timer for 3 hr noontime run - Runs off PV ||
|| Midnight Classic 200 | 10, Evergreen 200w in a 160VOC array ||
|| VEC1093 12V Charger | Maha C401 aa/aaa Charger | SureSine | Sunsaver MPPT 15A
solar: http://tinyurl.com/LMR-Solar
gen: http://tinyurl.com/LMR-ListerComment
Comment