Tweet
Should I do anything special with new AGM batteries before connecting them to my solar panels? Should I fully charge them or just hook them up and let the panels charge them before putting them into service?
-
-
This is probably obvious but all I would do is make sure your charge controller is set up for AGM.9 kW solar, 42kWh LFP storage. EV owner since 2012 -
The factor has a spec for the initial charging of batteries. It often involves a couple slow discharge and recharge cycles . The battery dealer should have access to the specs and share them with you.Powerfab top of pole PV mount (2) | Listeroid 6/1 w/st5 gen head | XW6048 inverter/chgr | Iota 48V/15A charger | Morningstar 60A MPPT | 48V, 800A NiFe Battery (in series)| 15, Evergreen 205w "12V" PV array on pole | Midnight ePanel | Grundfos 10 SO5-9 with 3 wire Franklin Electric motor (1/2hp 240V 1ph ) on a timer for 3 hr noontime run - Runs off PV ||
|| Midnight Classic 200 | 10, Evergreen 200w in a 160VOC array ||
|| VEC1093 12V Charger | Maha C401 aa/aaa Charger | SureSine | Sunsaver MPPT 15A
solar: http://tinyurl.com/LMR-Solar
gen: http://tinyurl.com/LMR-ListerComment
Comment